Whole reason I joined. So others can know to stay away from this if running enough to test the 10 kw coupler.
I will post which version mine is later tonight. Serial numbers off the top of my head is 01734. I will correct that later if I am wrong on the serial number when I can look at the meter. Presently I am at work 6 miles offshore.
Here are my results with the meter.
Here is what I have observed so far....... Still testing it though.
(Done all the testing and pill buying I am going to do with this meter now)Keyed with barefooted radio and talked for over 15 mins....... No Problems. Done this 3 times
Keyed with straight one driving straight two for 10 mins........ No Problems. Done this 3 times
Keyed with 8 pill in line for 10 mins..... talking local............... No Problems. Done this 2 times
already had blew up my 32 pill headcracka and 24 pill ghettoblaster with this meterGot 24 pill completed 2 days ago........
Keyed and talked on it........ 6 mins into the 10 mins and these weird ###### readings start showing up again........... So I stopped testing that night.
Next night after work....... I did not make it 6 mins before the readings would do it again.
So I check SWR on antenna with MFJ... Still good.
Read SWR going through coupler........ Not good. (The number that I was seeing on meter was telling me 3.07..... On MFJ 3.15) So the readings are close enough to compare.
________________________________
I took a 2 hour break.
Read swr through meter...... 1.11
MFJ.................................... 1.08 Still comparable.
________________________________
Put heat through it again with 24 pill........ made it 8 mins this time before funky ###### swrs show up.
Checked antenna
SWRs on MFJ direct to antenna........ 1.09 50.7 ohms
SWRs on LP100A............................ 5.67 MFJ through coupler 3.2 78.2 ohms,,,,,,,,
________________________________
Checked this morning no power at all through coupler.......
Looked at my ohms....... Direct to antenna....... 50.6
Looked though coupler.................................... 50.6
_________________________________
I think something is going wrong through either the sampler coil going to the pc board inside the coupler...... Or something on the pc board is changing value after a little heat is applied.
__________________________________
No big watts through the meter.... People should be fine. BIG WATTS need to stay with Bird is my opinion. I believe even big watts should be ok if they just use it to check the system out.... And not run it in system all the time........
10KW coupler- LPC5



And this is after I have ran the lp100a. It has not arced or sparked in the coupler.
In my opinion waste of money for someone who is wanting to run bigger power.